Native to the warm climates of South America, naranjilla
(Solanum quitoense) is a thorny,
spreading shrub that produces tropical blooms and small, orange fruit.
Naranjilla is usually propagated by seed or cuttings, but you can also
propagate naranjilla by layering.
Interested in learning how to layer naranjilla? Air
layering, which involves rooting a naranjilla branch while it’s
still attached to the parent plant, is surprisingly easy. Read on to learn
about naranjilla air layering propagation.
Tips on Naranjilla Layering
Air layering naranjilla is possible any time of year, but
rooting is best in early spring. Use a straight, healthy branch about one or
two years old. Remove the side shoots and leaves.
Using a sharp, sterile knife, make an angled, upward cut about one-third to halfway through the stem, thus creating a “tongue” about 1 to 1.5 inches (2.5-4 cm.) long. Place a piece of toothpick or a small amount of sphagnum moss in the “tongue” to keep the cut open.
Alternatively, make two parallel cuts about 1 to 1.5 inches
(2.5-4 cm.) apart. Carefully remove the ring of bark. Soak a fist-sized handful
of sphagnum moss in a bowl of water, then squeeze out the excess. Treat the
wounded area with powdered or gel rooting
hormone, then pack damp sphagnum moss around the cut area so the
entire wound is covered.
Cover the sphagnum moss with opaque plastic, such as a plastic grocery bag, to keep the moss moist. Make sure no moss is extending outside the plastic. Secure the plastic with string, twist-ties, or electrician’s tape, then cover the entire thing with aluminum foil.
Care While Air Layering Naranjilla
Remove the foil occasionally and check for roots. The branch
may root in two or three months, or rooting may take as long as a year.
When you see a ball of roots around the branch, cut the
branch from the parent plant below the root ball. Remove the plastic covering
but don’t disturb the sphagnum moss.
Plant the rooted branch in a container filled with good
quality potting mix. Cover the plastic for the first week to prevent loss of
moisture.
Water lightly as needed. Don’t allow the potting mix to dry
out.
Put the pot in light shade until the new roots are well developed,
which usually takes a couple of years. At that point, the new naranjilla is
ready for its permanent home.
Native to the warm climates of South America, naranjilla
(Solanum quitoense) is a thorny,
spreading shrub that produces tropical blooms and small, orange fruit.
Naranjilla is usually propagated by seed or cuttings, but you can also
propagate naranjilla by layering.
Interested in learning how to layer naranjilla? Air
layering, which involves rooting a naranjilla branch while it’s
still attached to the parent plant, is surprisingly easy. Read on to learn
about naranjilla air layering propagation.
Tips on Naranjilla Layering
Air layering naranjilla is possible any time of year, but
rooting is best in early spring. Use a straight, healthy branch about one or
two years old. Remove the side shoots and leaves.
Using a sharp, sterile knife, make an angled, upward cut about one-third to halfway through the stem, thus creating a “tongue” about 1 to 1.5 inches (2.5-4 cm.) long. Place a piece of toothpick or a small amount of sphagnum moss in the “tongue” to keep the cut open.
Alternatively, make two parallel cuts about 1 to 1.5 inches
(2.5-4 cm.) apart. Carefully remove the ring of bark. Soak a fist-sized handful
of sphagnum moss in a bowl of water, then squeeze out the excess. Treat the
wounded area with powdered or gel rooting
hormone, then pack damp sphagnum moss around the cut area so the
entire wound is covered.
Cover the sphagnum moss with opaque plastic, such as a plastic grocery bag, to keep the moss moist. Make sure no moss is extending outside the plastic. Secure the plastic with string, twist-ties, or electrician’s tape, then cover the entire thing with aluminum foil.
Care While Air Layering Naranjilla
Remove the foil occasionally and check for roots. The branch
may root in two or three months, or rooting may take as long as a year.
When you see a ball of roots around the branch, cut the
branch from the parent plant below the root ball. Remove the plastic covering
but don’t disturb the sphagnum moss.
Plant the rooted branch in a container filled with good
quality potting mix. Cover the plastic for the first week to prevent loss of
moisture.
Water lightly as needed. Don’t allow the potting mix to dry
out.
Put the pot in light shade until the new roots are well developed,
which usually takes a couple of years. At that point, the new naranjilla is
ready for its permanent home.